Installation guide

H323 > H323-STACKS CONFIGURATION ELEMENTS A-M
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 153
Notes This parameter is not RTC supported.
multicast—Enter the multicast address and port of the RAS Multicast IP Group
used for automatic gatekeeper discovery. In order to clear this field, you must enter
an empty string by typing a space. 224.0.1.41:1718 is the well known value used to
discover the Gatekeeper.
Default 0.0.0.0:0
Notes This parameter is not RTC supported.
gatekeeper—Enter the IP address and RAS port of the Gatekeeper. In order to
clear this field, you must enter an empty string.
Default 0.0.0.0:0
Notes This parameter is not RTC supported.
gk-identifier—Enter the gatekeeper identifier with which the H.323 stack registers
Values 1 to 128 characters
Notes This parameter is not RTC supported.
q931-port—Enter the Q.931 call signaling port. This is the port for the h323-stack:
local-ip address set above.
Default 1720
Values Min: 0 / Max: 65535
Notes This parameter is not RTC supported.
alternate-transport—Enter the alternate transport addresses and ports (i.e., the
Annex E address(es) and port(s)). If this field is left empty, the H.323 stack will not
listen for incoming Annex E requests.
Notes This parameter is not RTC supported.
q931-max-calls—Set the maximum number of concurrent, active calls allowed on
the Net-Net SBC. If this field value is exceeded, the H.323 stack returns a state of
“busy.”
Default 200
Values Min: 0 / Max: 65535
Notes This parameter is not RTC supported.
h245-tunneling—Enable or disable H.245 tunneling supported by this H.323 stack
Default disabled
Values enabled | disabled
Notes This parameter is not RTC supported.
fs-in-first-msg—Enable or disable Fast Start fields sent in the first message in
response to a SETUP message that contains Fast Start fields
Default disabled
Values enabled | disabled