Installation guide

H323 > H323-STACKS CONFIGURATION ELEMENTS A-M
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 155
Notes This command is not RTC supported.
h245-stage—Select the H.245 stage at which the Net-Net SBC allows either of the
following:
• Transfer of the H.245 address to remote side of the call
• Acting on the H.245 address sent by the remote side
Default connect
Values • setup
• proceeding
•alerting
• connect
• early
• facility
• noh245
• dynamic
q931-start-port—Set the starting port number for Q.931 port range used for Q.931
call signalling
Default 0
Values 0 | 1024 | 2048 | 4096 | 8192 | 16384 | 32768
q931-number-ports—Set the number of ports in Q.931 port range used for the
H.323 registration proxy feature
Default 0
Values 0 | 1024 | 2048 | 4096 | 8192 | 16384 | 32768
dynamic-start-port—Set the starting port number for Q.931 port range used for
the H.323 registration proxy feature
Default 0
Values 0 | 1024 | 2048 | 4096 | 8192 | 16384 | 32768
dynamic-number-ports—Enter the number of ports in port range used for
dynamic TCP connections the H.323 registration proxy feature
Default 0
Values 0 | 1024 | 2048 | 4096 | 8192 | 16384 | 32768
filename—Enter the name of the configuration file used to override the default
configuration. H.323 stack configuration is read from the file specified by this field
value. The configuration file does not override manually configured values; the
configuration uses the values you have configured plus the information that resides
in the file. This file resides in <default-dir>/H323CfgFile, where <defaultdir> is
usually /ramdrv.
Notes This parameter is not RTC supported.
tcp-keepalive—Enable or disable TCP keepalive processing on call-signaling port
Default disabled