Installation guide

156 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS A-M HOST-ROUTE
Values enabled | disabled
rfc2833-mode—Select whether 2833/UII negotiation will be transparent to the Net-
Net SBC (pre-4.1 behavior), or use 2833 for DTMF and signal it in its TCS
Default transparent
Values transparent | preferred
Path h323-stacks is a subelement under the h323 element. The full path from the
topmost ACLI prompt is: configure terminal > session-router > h323 > h323-
stacks.
Release First appearance: 1.2 / Most recent update: 4.1
RTC Status Supported
Notes This is a multiple instance configuration subelement.
host-route
The host-route configuration element establishes routing exceptions on the Net-
Net SBC for management traffic.
Syntax host-route <dest-network | netmask | gateway | description |
select | no | show | done | exit>
Parameters dest-network—Enter the IP address of the destination network for this host route.
No two host-route elements can have the same dest-network field value.
netmask—Enter the destination network subnet mask. The network-interface
element will not function properly unless this field value is valid.
gateway—Enter the gateway used to leave the local network. The gateway field
identifies the next hop to use when forwarding a packet out of the originator’s LAN.
description—Provide a brief description of this host-route configuration
Path host-route is an element under the system path. The full path from the topmost
ACLI prompt is: configure terminal > system > host-route.
Release First appearance: 1.0.1
RTC Status Supported
Notes This is a multiple instance configuration element.