Installation guide

158 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS A-M IPSEC
ipsec
The ipsec configuration element allows you to configure security policies and
security associations on your Net-Net SBC.
Syntax ipsec <security-policy | security-association | exit>
Parameters security-policy—Enter the security-policy configuration element
security-association—Enter the security-association configuration element
Path ipsec is an element of the security path. The full path from the topmost ACLI
prompt is: configure terminal > security> ipsec.
Release First appearance: 5.0
RTC Status Supported
ipsec>ipsec-global-config
The ipsec-global-config subelement allows you to configure establish the
parameters governing system-wide IPSec functions and behavior, including IPSec
redundancy.
Syntax ipsec-global-config <red-ipsec-port | red-max-trans | red-sync-
start-time | red-sync-comp-time | options | select | no | show |
done | exit>
Parameters red-ipsec-port—Enter the port on which the Net-Net SBC should listen for
redundancy IPSec synchronization messages
Default 1994
Values Min: 1025 / Max: 65535
red-max-trans—Enter the maximum number of redundancy transactions to retain
on the active
Default 10000
Values Min: 0 / Max: 999999999
red-sync-start-time—Enter the time in milliseconds before the system starts to
send redundancy synchronization requests
Default 5000
Min: 0 / Max: 999999999
red-sync-comp-time—Enter the time in milliseconds to define the timeout for
subsequent synchronization requests once redundancy synchronization has
completed
Default 1000