Installation guide

160 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS A-M IPSEC>SECURITY-ASSOCIATION>MANUAL
network-interface—Enter the network interface and VLAN where this security
association applies in the form of:
interface_name:VLAN
local-ip-addr—Enter the local IP address to match for traffic selectors for this SA
remote-ip-addr—Enter the remote IP address to match for traffic selectors for this
SA
local-port—Enter the local port to match for traffic selectors for this SA
Default 0
Values Min: 0 (disabled) / Max: 65535
remote-port—Enter the remote port to match for traffic selectors for this SA
Default 0
Values Min: 0 (disabled) / Max: 65535
trans-protocol—Select the transport protocol to match for traffic selectors for this
SA
Default ALL
Values • UDP
•TCP
•ALL
•ICMP
ipsec-protocol—Select the IPsec protocol used for this SA
Default esp
Values esp | ah
direction—Set the direction of traffic this security association can apply to
Default both
Values in | out | both
ipsec-mode—Select the IPsec mode of this SA
Default transport
Values tunnel | transport
auth-algo—Select the IPsec authentication algorithm for this SA
Default null
Values • hmac-md5
• hmac-sha1
• null
encr-algo—Enter the IPsec encryption algorithm for this SA
Default null
Values • des
•3des
• aes-128-cbc
• aes-256-cbc
• aes-128-ctr
• aes-256-ctr
•null