Installation guide

168 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS A-M LOCAL-RESPONSE-MAP
terminate-recursion—Terminate route recursion with this next hop
Default disabled
Values enabled | disabled
methods—Enter the SIP methods you want to use for matching this set of policy
attributes
Path policy-attributes is a subelement under the local-policy element. The full path
from the topmost ACLI prompt is: configure terminal > session-router > local-
policy > policy-attributes.
Release First appearance: 1.0 / Most recent update: S-C6.1.0
RTC Status Supported
Notes You must select a local-policy element to which you want to add policy attributes
before you enter those elements. If you do not select a local-policy element prior to
entering configurations for the policy attributes, your information will be lost. This
is a multiple instance configuration element.
local-response-map
The local-response-map configuration element is used for RFC3326 support.
Syntax local-response-map <entries | delete | edit | select | no | show |
done | exit>
Arguments entries—Enter the entries configuration subelement
delete—Remove the specified response map entry type
Values • invalid-message—response map for invalid message
• cpu-overload—response map for CPU overload
• media-released—response map for media released condition
• media-not-allocated—response map for media not allocated
edit—Select a pre-configured RFC 3326 response map to edit
Path local-response-map is an element under the session router path. The full path
from the topmost ACLI prompt is: configure terminal > session-router > local-
response-map.
Release First appearance: 4.0
RTC Status Supported