Installation guide

182 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS A-M MGCP-CONFIG
divisor—Enter the unit for computing name of an endpoint. This field is used to
determine the number for the LinePrefix or LineUnit. The remainder of the private
IP address divided by this number becomes the prefix/unit number. If FQDNs are
used for network addressing, the divisor field is not used.
Default 256
Values 256 | 65535 | 16777216 | 4294967296
unit-prefix—Enter the prefix for the unit term of the endpoint name. For modes
that add a unit term to the user part of the endpoint name, this field value is placed
in front of the unit number or name when creating a public endpoint name.
audit-interval—Enter the number of seconds between AUEP commands that the
Net-Net SBC sends to the endpoint (gateway/IAD). No AUEPs are sent by default.
Default 0
Values Min: 0 / Max: 999999999
nat-traversal—Enable or disable whether or not MGCP ALG assumes that all
(gateway) endpoints are behind a NAT
Default disabled
Values enabled | disabled
dns-authentication—Enable or disable MGCP DNS authentication functionality
on the Net-Net SBC
Default disabled
Values enabled | disabled
dns-translation—Enter the translation rule to use, i.e., what characters in the
address will be added, replaced, or deleted. If you enable the MGCP DNS
authentication feature, then this field is required. The value of this field must be a
configured session translation.
ca-redundancy—Enable or disable the call agent redundancy feature
Default disabled
Values enabled | disabled
ca-ping-method—Enter the ping method used for call agent redundancy. This
parameter is the prototype of a ping method sent to a call agent to determine its
state.
ca-ping-interval—Enter the amount of time in seconds between pings sent to the
call agent to check for health
Default 0
Values Min: 0 / Max: 999999999
rsip-failures—Enter the range of 5xx return codes that trigger MGCP endpoint
removal or that will fail to create an MGCP session. To empty the default, enter a
<Space> enclosed in quotation marks.
Default 500-509,511-519,522-599