Installation guide

186 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS N-Z NET-MANAGEMENT-CONTROL
realm-next-hop—Enter the realm identifier to designate the realm of the next hop
when the treatment type is
DIVERT
protocol-next-hop—Enter the signaling protocol for the next hop when the
treatment type is
DIVERT
status-code—Enter the SIP response code that you want the Net-Net SBC to use
when the treatment method is
REJECT
Default 503
Values Min: 1 / Max: 699
cause-code—Enter the Q.850 cause code that you want the Net-Net SBC to use
when the treatment method is
REJECT
Default 63
Values Min: 1 / Max: 999999999
gap-rate-max-count—Enter the maximum token counter value for gapping rate
Default 0
Values Min: 0 / Max: 999999999
gap-rate-window-size—Enter the window size (in seconds) for gapping rate
calculation
Default 0
Values Min: 0 / Max: 999999999
destination-identifier—Enter the classification key. This parameter specifies
information about the destination, which can be an IP address, an FQDN, and
destination (called) number, or destination prefix. You can wildcard characters in the
classification key using the carat symbol (^).
This parameter can accommodate a list of entries so that, if necessary, you can
specify multiple classification keys.
add-destination-identifier—Add a destination identifier
remove-destination-identifier—Remove a destination identifier
rph-feature—Set the state of NSEP support for this NMC rule
Default disabled
Values enabled | disabled
rph-profile—Enter the name of the RPH profile to apply to this NMC rule
Default None
Values Name of an rph-profile
rph-policy—Enter the name of the RPH policy to apply to this NMC rule
Default None
Values Name of an rph-policy
Path net-management-control is an element of the session-router path. The full path
from the topmost ACLI prompt is: configure terminal > session-router > net-
management-control.