Installation guide

NETWORK-INTERFACE CONFIGURATION ELEMENTS N-Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 187
Release First appearance: 4.1.1
RTC Status Supported
network-interface
The network-interface element creates and configures a logical network interface.
Syntax network-interface <name | sub-port-id | description | hostname |
ip-address | pri-utility-addr | sec-utility-addr | netmask |
gateway | sec-gateway | gw-heartbeat | dns-ip-primary | dns-ip-
backup1 | dns-ip-backup2 | dns-domain | dns-timeout | add-hip-ip
| remove-hip-ip | add-ftp-ip | remove-ftp-ip | add-icmp-ip |
remove-icmp-ip | add-snmp-ip | remove-snmp-ip | add-telnet-ip |
remove-telnet-ip | select | no | show | done | exit>
Parameters name—Enter the name of the physical interface with which this network-interface
element is linked. Network-interface elements that correspond to phy-interface
elements with an operation type of Control or Maintenance must start with
“wancom.”
sub-port-id—Enter the identification of a specific virtual interface in a physical
interface (e.g., a VLAN tag). A value of 0 indicates that this element is not using a
virtual interface. The sub-port-id field value is only required if the operation type is
Media.
Default 0
Values Min: 0 / Max: 4095
description—Enter a brief description of this network interface
hostname—Enter the hostname of this network interface. This is an optional entry
that must follow FQDN Format or IP Address Format.
ip-address—Enter the IP address of this network interface. This is a required entry
that must follow the IP Address Format.
pri-utility-addr—Enter the utility IP address for the primary HA peer in an HA
architecture
sec-utility-addr—Enter the utility IP address for the secondary Net-Net SBC peer
in an HA architecture
netmask—Enter the netmask portion of the IP address for this network interface
entered in IP address format. The network-interface element will not function
properly unless this field value is valid.
gateway—Enter the gateway this network interface uses to forward packets. Entries
in this field must follow the IP Address Format. No packets are forwarded if this
value is 0.0.0.0.
sec-gateway—Enter the gateway to use on the secondary Net-Net SBC in an HA
pair. Entries in this field must follow the IP address format.