Installation guide

NETWORK-INTERFACE > GW-HEARTBEAT CONFIGURATION ELEMENTS N-Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 189
network-interface > gw-heartbeat
The gw-heartbeat subelement supports the front interface link failure detection and
polling feature.
Syntax gw-heartbeat <state | heartbeat | retry-count | retry-timeout |
health-score | select | no | show | done | exit>
Parameters state—Enable or disable front interface link detection and polling functionality on
the Net-Net SBC for this network-interface element
Default enabled
Values enabled | disabled
heartbeat—Enter the time interval in seconds between heartbeats for the front
interface gateway
Default 0
Values Min: 0 / Max: 65535
retry-count—Enter the number of front interface gateway heartbeat retries before a
gateway is considered unreachable
Default 0
Values Min: 0 / Max: 65535
retry-timeout—Enter the heartbeat retry timeout value in seconds
Default 1
Values Min: 1 / Max: 65535
health-score—Enter the amount to subtract from the health score if the front
interface gateway heartbeat fails (i.e., expires). The health score will be decremented
by the amount set in this field if the timeout value set in the gw-heartbeat: retry-
timeout field is exceeded without the front interface gateway sending a response.
Default 0
Values Min: 0 / Max: 100
Path gw-heartbeat is a subelement of the network-interface element. The full path from
the topmost ACLI prompt is: configure terminal > system > network-interface >
gw-heartbeat.
Release First appearance: 1.2.1
RTC Status Supported
Notes The values configured in the fields of a gw-heartbeat subelement apply to the Net-
Net SBC on a per-network-interface basis, and can override the values configured
in the redundancy element’s corresponding front interface link detection and
polling fields.
This is a single instance configuration subelement.