Installation guide

190 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS N-Z NETWORK-PARAMETERS
network-parameters
The network-parameters element enables and configures the TCP keepalive
feature used for keeping H.323 connections open.
Syntax network-parameters <tcp-keepalive-count | tcp-keepalive-timer |
tcp-keepalive-mode | tcp-keepinit-timer | tcp-keepalive-interval-
timer | sctp-send-mode | options | show | done | exit>
Parameters tcp-keepalive-count—Enter the number of outstanding keepalives before
connection is torn down
Default 8
Values Min: 0 / Max: 2
32-
1
tcp-keepalive-idle-timer—Enter the idle time in seconds before triggering
keepalive processing. If you have upgraded the release you are running and a value
outside of the acceptable range was configured in an earlier release, the default
value is used and a log message is generated.
Default 7200
Values Min: 30 / Max: 7200
tcp-keepalive-mode—Enter the TCP keepalive mode
Default 0
Values • 0—The sequence number is sent un-incremented
• 1—The sequence number is sent incremented
• 2—No packets are sent
tcp-keepinit-timer—Enter the TCP connection timeout period if a TCP connection
cannot be established. If you have upgraded the release you are running and a value
outside of the acceptable range was configured in an earlier release, the default value
is used and a log message is generated.
Default 75
Values 0-999999999
tcp-keepalive-interval-timer—Enter the TCP retransmission time if a TCP
connection probe has been idle for some amount of time
Default 75
Values Min: 15 / Max: 75
sctp-send-mode—Leave this parameter set to its default (unordered) so data
delivery can occur without regard to stream sequence numbering. If data delivery
must follow stream sequence number, change this parameter to ordered.
Default unordered
Values ordered | unordered
options—Enter any optional features or parameters