Installation guide

192 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS N-Z NTP-SYNC
ntp-sync
The ntp-sync element sets the ntp server IP address for correct and accurate time
synchronization.
Syntax ntp-sync <add-server | del-server | select | no | show | done |
exit>
Parameters add-server—Add IP address of NTP server; entries must follow the IP Address
Format
del-server—Remove a previously entered NTP server. Entries must follow the IP
Address Format.
Path ntp-sync is a top-level element. The full path from the topmost ACLI prompt is:
configure terminal > ntp-sync.
Release First appearance: 1.0 / Most recent update: 1.1
RTC Status Unsupported
Notes In order for any changes to the NTP synchronization functionality to take effect, a
save-config must be performed followed by a system reboot.
qos-constraints
The qos-constraints configuration element allows you to enable QoS based
routing, which uses the R-Factor on a per-realm basis to either cut back on the traffic
allowed by a specific realm.
Syntax qos-constraints <name | state | major-factor | critical-factor |
call-load-reduction | select | no | show | done | exit>
Parameters name—Enter the name of a QoS constraints configuration
state—Enable or disable a set of QoS constraints
Default enabled
Values enabled | disabled
major-factor—Enter a numeric value set the threshold that determines when the
Net-Net SBC applies the call reduction rate; must be less than the critical-rfactor
Default 0
Values Min: 0 / Max: 9321
critical-rfactor—Enter a numeric value to set the threshold that determines when
the Net-Net SBC rejects all inbound calls for the realm, and rejects outbound calls
when there is no alternate route
Default 0
Values Min: 0 / Max: 9321