Installation guide

PASSWORD-POLICY CONFIGURATION ELEMENTS N-Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 193
call-load-reduction—Enter the percentage by which the Net-Net SBC will reduce
calls to the realm if the major-rfactor is exceeded; a value of 0 means the call load
will not be reduced
Default 0
Values Min: 0 / Max: 100
Path qos-constraints is an element under the session-router path. The full path from
the topmost ACLI prompt is: configure terminal > session-router> qos-
constraints.
Release First appearance: S-C6.1.0
RTC Status Supported
password-policy
The password-policy element configures password rules for password secure
mode.
Syntax password-policy <min-secure-pwd-len | select | no | show | done |
exit>
Parameters min-secure-pwd-len—Enter the minimum password length to use when system
is in secure password mode. The maximum allowable length for any password is 64
characters.
Default 8
Values 8-64
Default
Path password-policy is an element under the security path. The full path from the
topmost ACLI prompt is: configure terminal> security> password-policy.
Release First appearance: 5.1
RTC Status Supported
Notes The password using this minimum length value must contain three out of four of
these requirements: upper case letters, lower case letters, numbers, punctuation
marks.
phy-interface
The phy-interface element is used to configure physical interfaces.
Syntax phy-interface <name | operation-type | port | slot | virtual-mac |
admin-state | auto-negotiation | duplex-mode | speed | wancom-
health-score | select | no | show | done | exit>