Installation guide

194 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS N-Z PHY-INTERFACE
Parameters name—Enter the name for this physical interface. Physical interfaces with an
operation-type of Control or Maintenance must begin with “wancom.” This is a
required field. Entries in this field must follow the Name Format. Name values for
the phy-interface must be unique.
operation-type—Select the type of physical interface connection
Default Control
Values • Media—Front-panel interfaces only. Port: 0-3 Slot: 0 or 1
• Control—Rear-panel interfaces only. Port 0, 1, or 2 Slot: 0
• Maintenance—Rear-panel interfaces only. Port 0, 1, or 2 Slot: 0
port—Select the physical port number on an interface of the phy-interface being
configured
Default 0
Values • 0-2 for rear-panel interfaces
• 0-1 for two possible GigE ports on front of Net-Net SBC chassis
• 0-3 for four possible FastE ports on front of Net-Net SBC chassis
slot—Select the physical slot number on the Net-Net SBC chassis
Default 0
Values • 0 is the motherboard (rear-panel interface) if the name begins with
“wancom”
• 0 is the left Phy media slot on front of Net-Net SBC chassis
• 1 is the right Phy media slot on front of Net-Net SBC chassis
virtual-mac—Enter the MAC address identifying a front-panel interface when the
Net-Net SBC is in the Active state. This field value should be generated from the
unused MAC addresses assigned to a Net-Net SBC. The virtual-mac field is only
applicable for front interfaces.
admin-state—Enable or disable the Net-Net SBC to allow incoming and outgoing
traffic to be processed using the front physical interface cards
Default enabled
Values enabled | disabled
auto-negotiation—Enable or disable auto negotiation on front Phy card interfaces
taking place before either end begins sending packets over the Ethernet link. The
auto-negotiation field is only applicable for front interfaces. The value configured in
this field does not change the Net-Net SBC status at runtime.
Default enabled
Values enabled | disabled
duplex-mode—Set whether the 10/100 Phy card interfaces located on the front
panel of Net-Net SBC operate in full-duplex mode or half-duplex mode
Default full
Values full | half