Installation guide

Q850-SIP-MAP CONFIGURATION ELEMENTS N-Z

Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 195

speed—Set the speed in Mbps of the front-panel 10/100 Phy interfaces; this field is

only used if the auto-negotiation field is set to disabled for 10/100 Phy cards

Default 100

Values 10 | 100

wancom-health-score—Enter the amount to subtract from the Net-Net SBC’s

health score if a rear interface link goes down

Default 50

Values Min: 0 / Max: 100

Notes This parameter is not RTC supported

Path phy-interface is an element under the system path. The full path from the topmost

ACLI prompt is: configure terminal > system > phy-interface.

Release First appearance: 1.0 / Most recent update: 1.2.1

RTC Status Supported

Notes Certain fields are visible based on the setting of the operation-type parameter. This

is a multiple instance configuration subelement.

q850-sip-map

The q850-sip-map configuration element is used to map q850 cause codes to SIP

response codes.

| exit>

Parameters entries—Enter the entries configuration subelement

delete—Delete a q850 to SIP mapping. Enter the q850 code.

edit—Edit a response map by number

Path q850-sip-map is an element under the session-router path. The full path from the

topmost ACLI prompt is: configure terminal > session-router > q850-sip-map.

Release First appearance: 4.0

RTC Status Supported

q850-sip-map > entries

The entries subelement is used to create the mapping of q850 cause to SIP reason

code.

| done | exit>