Installation guide

196 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS N-Z REALM-CONFIG
Parameters q850-cause—Enter the q850 cause code to map to a SIP reason code
sip-status—Enter the SIP response code that maps to this q850 cause code
Values Min: 100 / Max: 699
sip-reason—Describe the mapped SIP response code
Path entries is a subelement under the q850-sip-map configuration element, which is
located under the session-router path. The full path from the topmost ACLI prompt
is: configure terminal > session-router > q850-sip-map > entries.
Release First appearance: 4.0
RTC Status Supported
realm-config
The realm-config element is used to configure realms.
Syntax realm-config <identifier | description | addr-prefix | network-
interfaces | mm-in-realm | mm-in-network | msm-release | qos-
enable | max-bandwidth | ext-policy-svr | max-latency | max-
jitter | max-packet-loss | observ-window-size | parent-realm |
dns-realm | media-policy | class-profile | in-translationid |
out-translationid | in-manipulationid | out-manipulationid |
early-media-allow | additional-prefixes | add-additional-prefixes
| remove-additional-prefixes | accounting-enable | mm-same-ip |
mm-in-system | untrusted-signal-threshold | restricted-latching |
restriction-mask | average-rate-limit | access-control-trust-
level | invalid-signal-threshold | maximum-signal-threshold |
deny-period | symmetric-latching | pai-strip | trunk-context |
bw-cac-non-mm | user-cac-mode | user-cac-bandwidth | user-cac-
sessions | monthly-minutes | net-management-control | delay-
media-update | refer-call-transfer | codec-policy | codec-manip-
in-realm | generate-udp-checksum | enforcement-profile | options
| constraint-name | call-recording-server-id | icmp-detect-
multiplier | icmp-advertisement-interval | icmp-target-ip |
fallback-bandwidth | max-priority-bandwidth | nat-trust-treshold
| match-media-profiles | qos-constraints | stun-enable | stun-
server-ip | stun-server-port | stun-changed-ip | stun-changed-
port | select | no | show | done | exit>
Parameters identifier—Enter the name of the realm associated with this Net-Net SBC. This is a
required field. The identifier field value must be unique.
description—Provide a brief description of the realm-config configuration
element
addr-prefix—Enter the IP address prefix used to determine if an IP address is
associated with the realm. This field is entered as an IP address and number of bits
in the network portion of the address in standard slash notation.
Default 0.0.0.0