Installation guide

198 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS N-Z REALM-CONFIG
Default 0
Values Min: 0 / Max: 2
32
-1
max-jitter—Enter the maximum jitter in milliseconds allowed for flows within this
realm. If this field is set to 0, then no alarm condition is set and no requests to/from
the realm are rejected. Reserved for future use.
Default 0
Values Min: 0 / Max: 2
32
-1
max-packet-loss—Enter the maximum packet loss percentage in hundredths of a
percent allowed for flows within this realm. If this parameter is set to 0, then no
alarm condition is set and no requests to/from the realm are rejected. Reserved for
future use.
Default 0
Values Min: 0 / Max: 2
32
-1
observ-window-size—Enter the minimum time in milliseconds a threshold
(latency, jitter, and packet loss) must be exceeded before triggering an alarm.
Reserved for future use.
Default 0
Values Min: 0 / Max: 2
32
-1
parent-realm—Enter the parent realm for this particular realm. This must
reference an existing realm identifier.
dns-realm—Enter the realm whose network interface’s DNS server should be used
to resolve FQDNs for requests sent into the realm. If this field value is left empty,
the Net-Net SBC will use the DNS of the realm’s network interface.
media-policy—Select a media-policy on a per-realm basis (via an association
between the name field value configured in this field). When the Net-Net SBC first
sets up a SIP or H.323 media session, it identifies the egress realm of each flow and
then determines the media-policy element to apply to the flow. This parameter
must correspond to a valid name entry in a media policy element.
class-profile—Enter the name of class-profile to use for this realm for ToS marking
in-translationid—Enter the identifier/name of a session-translation element. The
Net-Net SBC applies this group of rules to the incoming addresses for this realm.
There can be only one entry in this parameter.
out-translationid—Enter the identifier/name of a session-translation element. The
Net-Net SBC applies this group of rules to the outgoing addresses for this realm.
There can be only one entry in this parameter.
in-manipulationid—Enter the inbound SIP manipulation rule name
out-manipulationid—Enter the outbound SIP manipulation rule name