Installation guide

REALM-CONFIG CONFIGURATION ELEMENTS N-Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 199
early-media-allow—Select the early media suppression for the realm
Values • none: No early media is allowed in either direction
• both: Early media is allowed in both directions
• reverse: Early media received by Net-Net SBC in the reverse direction
is allowed
additional-prefixes—Enter one or more additional address prefixes. Not
specifying the number of bits to use implies all 32 bits of the address are used to
match.
add-additional-prefixes—Add one or more additional address prefixes. Not
specifying the number of bits to use implies all 32 bits of the address are used to
match.
remove-additional-prefixes—Remove one or more additional address prefixes.
Not specifying the number of bits to use implies all 32 bits of the address are used to
match.
accounting-enable—Select whether you want accounting enabled within the
realm
Default enabled
Values enabled | disabled
mm-same-ip—Enable the media to go through this Net-Net SBC if the mm-in-
realm . When not enabled, the media will not go through the Net-Net SBC for
endpoints that are behind the same IP.
Default enabled
Values enabled | disabled
mm-in-system—Decide whether to do media managing in the Net-Net SBC
Default enabled
Values enabled | disabled
untrusted-signal-threshold—Enter the allowed maximum signaling messages
within a tolerance window
Default 0
Values Min: 0 / Max: 4294967295
restricted-latching—Set the restricted latching mode
Default None
Values • none: No restricted latching
• sdp: Use the IP address specified in the SDP for latching purpose
• peer-ip: Use the peer-ip (Layer 3 address) for the latching purpose
restriction-mask—Set the restricted latching mask value
Default 32
Values Min: 1 / Max: 32