Installation guide

REDUNDANCY CONFIGURATION ELEMENTS N-Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 207
basis by the value configured in the gw-heartbeat: heartbeat field of the gw-
heartbeat subelement in the network-interface element.
Default 0
Values Min: 0 / Max: 65535
Notes This parameter is not RTC supported.
gateway-heartbeat-retry—Enter the number of front interface gateway heartbeat
retries after a front interface gateway failure occurs. The value configured in this
field applies globally to Net-Net SBCs operating in HA pair architectures, but can
be overridden on a per network interface basis by the value configured in the gw-
heartbeat: retry-count field.
Default 0
Values Min: 0 / Max: 65535
Notes This parameter is not RTC supported.
gateway-heartbeat-timeout—Enter the heartbeat retry timeout value in seconds
between subsequent ARP requests to establish front interface gateway
communication after a front interface gateway failure occurs. The value configured
in this field applies globally to Net-Net SBCs operating in HA pair architectures, but
can be overridden on a network interface basis by the value configured in the gw-
heartbeat: retry-timeout field.
Default 1
Values Min: 0 / Max: 65535
Notes This parameter is not RTC supported.
gateway-heartbeat-health—Enter the health score amount to subtract if the
timeout value set in the gateway-heartbeat-timeout field has been exceeded
without receiving a response from the front interface gateway. The value configured
in this field applies globally to Net-Net SBCs operating in HA nodes, but can be
overridden on a network interface basis by the value configured in the gw-heartbeat
> health-score field of the gw-heartbeat. A field value of 0 means that the health
score is not affected.
Default 0
Values Min: 0 / Max: 100
Notes This parameter is not RTC supported.
media-if-peercheck-time—Enter the amount of time in milliseconds for the
standby system in an HA node to receive responses to its ARP requests via the front
interface before it takes over the active role from its counterpart. A value of 0 turns
the HA front interface keepalive off.
Default 0
Values Min: 0 / Max: 500
peers—Access the peers subelement
Path redundancy is an element under the system path. The full path from the topmost
ACLI prompt is: configure terminal > system > redundancy.