Installation guide

208 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS N-Z REDUNDANCY > PEERS
Release First appearance: 1.1 / Most recent update: 1.2.1
RTC Status This element has both supported and unsupported parameters. Unsupported
parameters are marked with a note.
Notes This is a single instance configuration element.
redundancy > peers
The peers subelement establishes the name and state of an HA node.
Syntax peers <name | state | type | destinations | select | no | show |
done | exit>
Parameters name—Enter the hostname of the HA Net-Net SBC peer. The name configured in
this field identifies each Net-Net SBC in an HA node uniquely.
state—Enable or disable HA
Default enabled
Values enabled | disabled
type—Select the HA peer type and which utility address to use
Default unknown
Values • primary—HA peer set as the primary Net-Net SBC. It is associated
with the utility address configured in the pri-utility-addr field of each
network-interface element.
• secondary—HA peer set as the secondary Net-Net SBC. It is
associated with the utility address configured in the sec-utility-addr
field of each network-interface element.
• unknown—Not assigned HA peer type with associated utility address
unknown. This type field option is not valid for configuration
checkpointing. Although unknown is the default value, Primary or
Secondary field option must be set in order for configuration
checkpointing to function properly.
destinations—Access the destinations subelement
Path peers is a subelement under the redundancy element. The full path from the
topmost ACLI prompt is: configure terminal > system > redundancy > peers.
Release First appearance: 1.0.1 / Most recent update: 1.2.1
RTC Status Unsupported
Notes This is a multiple instance configuration subelement.