Installation guide

REDUNDANCY > PEERS > DESTINATIONS CONFIGURATION ELEMENTS N-Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 209
redundancy > peers > destinations
The destinations subelement establishes locations where health and state
information is sent and received.
Syntax destinations <address | network-interface | select | no | show |
done | exit>
Parameters address—Enter the IP address and port on the interface of the HA Net-Net SBC
peer where this HA Net-Net SBC peer sends HA messages. The parameter format
is an IP address and port combination (IP address:port). This IP address must match
the interface identified in its HA Net-Net SBC peer’s corresponding rdncy-peer-
dest > network-interface field. The port portion of this parameter must match the
port identified in its HA Net-Net SBC peer’s corresponding port field.
network-interface—Enter the name and subport ID of the interface where the HA
Net-Net SBC receives HA messages (e.g., wancom1:0). Valid interface names are
wancom1 and wancom2 only.
Path destinations is a subelement under the peers subelement. The full path from the
topmost ACLI prompt is: configure terminal > system > redundancy > peers >
destinations.
Release First appearance: 1.0.1
RTC Status Unsupported
Notes The destinations prompt is displayed as: rdncy-peer-dest.
This is a multiple instance configuration element.
rph-policy
The rph-policy element defines an override resource value and an insert resource
value for ETS/WPS namespaces. These are applied to NMC rules.
Syntax rph-policy <name | override-r-value | insert-r-value | select |
no | show | done | exit>
Parameters name—Enter the name of this RPH policy; this is the value used when applying
this RPH policy to an NMC rule.
Default None
override-r-value—Set the value the Net-Net SBC uses to override the r-values in
the original RPH.
Default None
insert-r-value—Set the value the Net-Net SBC inserts into the RPH.
Path rph-policy is an element under the session-router path. The full path from the
topmost ACLI prompt is: configure terminal > session-router> rph-policy.
Release First appearance: 5.1