Installation guide

SESSION-AGENT CONFIGURATION ELEMENTS N-Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 211
session-agent
The session-agent element defines a signaling endpoint that can be configured to
apply traffic shaping attributes and information regarding next hops or previous
hops.
Syntax session-agent <hostname | ip-address | port | state | app-
protocol | app-type | transport-method | realm-id | egress-realm-
id | description | carriers | allow-next-hop-lp | constraints |
max-sessions | max-outbound-sessions | max-burst-rate | max-
sustain-rate | time-to-resume | ttr-no-response | in-service-
period | burst-rate-window | sustain-rate-window | req-uri-
carrier-mode | proxy-mode | redirect-action | loose-routing |
send-media-session | response-map | ping-method | ping-interval |
ping-send-mode | options | media-profiles | in-translationid |
out-translationid | trust-me | request-uri-headers | stop-recurse
| local-response-map | | ping-to-user-part | ping-from-user-part
| li-trust-me | in-manipulationid | out-manipulationid | p-
asserted-id | trunk-group | max-register-sustain-rate | min-
seizures | min-asr | early-media-allow | invalidate-registrations
| rfc2833-mode | rfc2833-payload | max-inbound-sessions | max-
inbound-burst-rate | max-outbound-burst-rate | max-inbound-
sustain-rate | codec-policy | enforcement-profile | refer-call-
transfer | reuse-connections | tcp-keepalive | tcp-reconn-
interval | max-register-burst-rate | register-burst-window |
ping-in-service-response-codes | out-service-response codes |
manipulation-string | select | no | show | done | exit>
Parameters hostname—Enter the hostname of this session agent. This is a required entry that
must follow the Hostname (or FQDN) Format or the IP Address Format. Hostname
values must be unique.
ip-address—Enter the IP address of session agent if hostname value is an FQDN
port—Enter the port number for this session agent.
Default 5060
Values Min: 0; 1025 / Max: 65535
state—Enable or disable the session agent
Default enabled
Values enabled | disabled
app-protocol—Select the signaling protocol used to signal with the session agent
Default SIP
Values H323 | SIP
app-type—Set the H.323 session agent type as a gateway or a gatekeeper. This
field is mandatory if the app-protocol parameter is set to H323. If the app-protocol
parameter is set to SIP, then this field must be left blank.
Values H323-GW | H323-GK