Installation guide

SESSION-AGENT CONFIGURATION ELEMENTS N-Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 213
max-outbound-sessions—Enter the maximum number of simultaneous outbound
sessions that are allowed to the session agent; 0 means there is no constraint
Default 0
Values Min: 0 / Max: 2
32
-1
max-burst-rate—Enter the number of session invitations per second allowed to be
sent to or received from the session agent. A session is rejected if the calculated per-
second rate exceeds this value.
Default 0
Values Min: 0 / Max: 2
32
-1
max-sustain-rate—Enter the maximum rate of session invitations per second
allowed to or from the session agent within the current window. The period of time
over which the rate is calculated is always between one and two window sizes. A
session is rejected only if the calculated per-second rate exceeds the max-sustain-
rate value. The value set for the max-sustain-rate field must be larger than the value
set for the max-burst-rate field.
Default 0
Values Min: 0 / Max: 2
32
-1
time-to-resume—Enter the time in seconds after which SIP or H.323 proxy should
resume sending session invitations to this session agent. This value only takes effect
when the proxy stops sending invitations because a constraint is exceeded.
Default 0
Values Min: 0 / Max: 2
32
-1
ttr-no-response—Enter the time delay in seconds the SIP or H.323 proxy must
wait from the time that it sends an invitation to a session-agent and gets no
response before it tries again to elicit a response from a previously unresponsive
session agent
Default 0
Values Min: 0 / Max: 2
32
-1
in-service-period—Enter the time in seconds the session-agent must be
operational (once communication is re-established) before the session agent is
declared to be in-service. This value gives the session agent adequate time to
initialize.
Default 0
Values Min: 0 / Max: 2
32
-1
burst-rate-window—Enter the burst window period in seconds used to measure
the burst rate. The term “window” refers to the period of time over which the burst
rate is computed.
Default 0
Values Min: 0 / Max: 2
32
-1