Installation guide

SESSION-AGENT CONFIGURATION ELEMENTS N-Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 217
Values • none—No early media allowed
• reverse—Allow early media in the direction of calling endpoint
• both—Allow early media in both directions
invalidate-registrations—Enable or disable the invalidation of all the registrations
going to this SA when its state transitions to “out of service”
Default disabled
Values enabled | disabled
rfc2833-mode— Select whether 2833/UII negotiation will be transparent to the
Net-Net SBC (pre-4.1 behavior), or use 2833 for DTMF
Default none
Values • none—The 2833-UII interworking will be decided based on the h323-
stack configuration.
• transparent—The session-agent will behave exactly the same way as
before and the 2833 or UII negotiation will be transparent to the Net-
Net SBC. This overrides any configuration in the h323-stack even if the
stack is configured for “preferred” mode.
• preferred—The session-agent prefers to use 2833 for DTMF transfer
and would signal that in its TCS. However, the final decision depends
on the remote H323EP.
rfc2833-payload—Enter the payload type used by the SA in preferred rfc2833-
mode
Default 0
Values Valid Range: 0, 96-127
Note: When this value is zero, the global “rfc2833-payload” configured
in the H323 configuration element will be used instead. For SIP SA, the
payload defined in the SIP Interface will be used, if the SIP-I is
configured with rfc2833-mode as “preferred”.
max-inbound-sessions—Enter the maximum number of inbound sessions allowed
from this session agent
Default 0
Values Min: 0 / Max: 999999999
max-inbound-burst-rate—Enter the maximum inbound burst rate in INVITEs per
second from this session agent
Default 0
Values Min: 0 / Max: 999999999
max-outbound-burst-rate—Enter the maximum outbound burst rate in INVITEs
per second
Default 0
Values Min: 0 / Max: 999999999
max-inbound-sustain-rate—Enter the maximum inbound sustain rate in INVITEs
per second