Installation guide

SESSION-AGENT-GROUP CONFIGURATION ELEMENTS N-Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 221
strategy—Select the session agent allocation options for the session-agent-group.
Strategies determine how session agents will be chosen by this session-agent-
group element.
Default Hunt
Values • Hunt—Selects session agents in the order in which they are listed
• RoundRobin—Selects each session agent in the order in which they
are listed in the dest list, selecting each agent in turn, one per session.
After all session agents have been used, the first session agent is used
again and the cycle continues.
• LeastBusy—Selects the session agent that has the fewest number of
sessions relative to the max-outbound-sessions constraint or the max-
sessions constraint (i.e., lowest percent busy) of the session-agent
element
• PropDist—Based on programmed, constrained session limits, the
Proportional Distribution strategy proportionally distributes the traffic
among all of the available session-agent elements
• LowSusRate—Routes to the session agent with the lowest sustained
rate of session initiations/invitations
dest—Enter the destinations (i.e., next hops) available for use by this session agent
group. If this list is configured, it can contain as many destinations as necessary. A
dest list value must correspond to a valid group name in another session agent
group or to a valid hostname.
trunk-group—Enter trunk group names and trunk group contexts to match in
either IPTEL or custom format. If left blank, the Net-Net SBC uses the trunk group
in the realm for this session agent group. Multiple entries are surrounded in
parentheses and separated from each other with spaces.
Entries for this list must one of the following formats: trgp:context or
trgp.context.
sag-recursion—Enable or disable SIP SAG recursion for this SAG
Default disabled
Values enabled | disabled
stop-sag-recurse—Enter the list of SIP response codes that terminate recursion
within the SAG. On encountering the specified response code(s), the Net-Net SBC
returns a final response to the UAC. You can enter the response codes as a comma-
separated list or as response code ranges.
Default 401, 407
Path session-agent-group is an element under the session-router path. The full path
from the topmost ACLI prompt is: configure terminal > session-router >
session-group.
Release First appearance: 1.0 / Most recent update: 1.2.1
RTC Status Supported
Notes This is a multiple instance configuration element.