Installation guide

SESSION-ROUTER-CONFIG CONFIGURATION ELEMENTS N-Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 225
max-outbound-sustain-rate—For the SIP method you set in the method
parameter, enter the number to restrict the outbound sustain rate on the SIP
interface where you apply these constraints
Default 0
Values Min: 0 / Max: 999999999
Path session-constraints> rate-constraints is an element of the session-router path.
The full path from the topmost ALCI prompt is: configure terminal > session-
router > session-constraints > rate-constraints.
Release First appearance: 5.1.1
RTC Status Supported
session-router-config
The session-router-config element allows you to configure whether or not session-
related functionality is enabled within your network, whether it contains a Net-Net
SBC SR or SD.
Syntax session-router <state | system-number-type | sr-primary-name |
sr-primary-address | sr-secondary-name | sr-secondary-address |
divide-resources | session-directors | holidays | match-lp-src-
parent-realms | nested-realm-stats | forced-report-trunk-info |
select | no | show | done | exit>
Parameters state—Enable or disable this session-related functionality on the system
Default enabled
Values enabled | disabled
system-number-type—Define the telephone number format used in local policy
and local policy lookups
Default Pots
Values • Pots—Telephone numbers are in Decimal routing number format (0-
9). This is the default and recommended setting.
• E164—Telephone numbers are in E.164 format as defined by the
global-number format of the tel URI defined in RFC 3966
• Routing—Telephone numbers are in Penta Decimal routing numbers
(0-9, A-F). This value is not currently used but reserved for future
enhancements.
sr-primary-name—Enter the name of the primary session router; must match the
target name in the boot parameters of the primary SR
sr-primary-address—Enter the IP Address of the maintenance interface of the
primary session router; must match the "inet on ethernet" address in the boot
parameters of the primary SR