Installation guide

226 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS N-Z SESSION-ROUTER-CONFIG
sr-secondary-name—Enter the name of the secondary session router; must match
the target name in the boot parameters of the secondary SR
sr-secondary-address—Enter the IP Address of the maintenance interface of the
secondary session router. This must match the "inet on ethernet" address in the
boot parameters of the secondary SR.
divide-resources—Indicate whether or not resources are divided by the number of
configured session directors. This includes:
• realm-config bandwidth
• session-agent max-sessions
• session-agent max-outbound-sessions
• session-agent max-burst-rate
• session-agent max-sustain-rate
Default disabled
Values enabled | disabled
match-lp-src-parent-realms—Enable or disable local policy parent realm
matching based on a parent realm
Default disabled
Values enabled | disabled
nested-realm-stats—Enable or disable using session constraints for nested realms
across the entire system
Default disabled
Values enabled | disabled
forced-report-trunk-info—Enable or disable generation of VSAs for trunk group
information even when you are not using trunk-group routing; VSAs 65-68 to report
originating and terminating trunk group information
Default disabled
Values enabled | disabled
session-directors—Access the session-directors subelement
holidays—Access the session-router-holidays subelement
Path session-router-config is an element under the session-router path. The full path
from the topmost ACLI prompt is: configure terminal > session-router >
session-router.
Release First appearance: 1.0 / Most recent update: S-C6.1.0
RTC Status Supported
Notes This is a single instance configuration element.