Installation guide

SIP-INTERFACE CONFIGURATION ELEMENTS N-Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 237
uri-fqdn-domain—Change the host part of the URIs to the FQDN value set here.
This applies to the Request-URI, From header, and To header in non-dialog
requests sent from the SIP interface.
options—Enter optional features and/or parameters
trust-mode—Select the trust mode for this SIP interface
Default all
Values • all—Trust all previous and next hops except untrusted session agents
• agents-only—Trust only trusted session agents
• realm-prefix—Trust only trusted session agents or address matching
realm prefix
• registered—Trust only trusted session agents or registered endpoints
• None—Trust nothing
sip-dynamic-hnt—Enable or disable adaptive HNT
Default disabled
Values enabled | disabled
max-nat-interval—Enter the amount of time in seconds that testing should not
exceed for adaptive HNT. The Net-Net SBC will keep the expires interval at this
value.
Default 3600
Values Min: 0 / Max: 999999999
nat-int-increment—Enter the amount of time in seconds to use as the increment
in value in the SIP expires header for adaptive HNT
Default 10
Values Min: 0 / Max: 999999999
nat-test-increment—Enter the amount of time in seconds that will be added to the
test timer for adaptive HNT
Default 30
Values Min: 0 / Max: 999999999
stop-recurse—Enter a list of returned response codes that this SIP interface will
watch for in order to stop recursion on the target’s or contact’s messages
port-map-start—Set the starting port for the range of SIP ports available for SIP
port mapping. A value of 0 disables SIP port mapping.
Default 0
Values Min: 1025 / Max: 65535
port-map-end—Set the ending port for the range of SIP ports available for SIP
port mapping. A value of 0 disables SIP port mapping. This value must be larger
than the port-map-start parameter’s value.
Default 0