Installation guide

24 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
HOW TO USE THE ACLI WORKING WITH CONFIGURATION ELEMENTS
payload-type
transport rtp
req-bandwidth 100
frames-per-packet 500
parameters
average-rate-limit 50
peak-rate-limit 55
max-burst-size 100
sdp-rate-limit-headroom 10
sdp-bandwidth disabled
Using Done to Save
Elements
We strongly recommend that you save your configuration information as you work.
This ensures that your configurations have been written to the system database.
Every menu contains the done command.
ACMEPACKET(snmp-community)# show
snmp-community
community-name Acme_Community
access-mode READ-ONLY
ip-addresses
10.0.0.2
10.0.0.3
10.0.0.4
ACMEPACKET(snmp-community)# done
snmp-community
community-name Acme_Community
access-mode READ-ONLY
ip-addresses
10.0.0.2
10.0.0.3
10.0.0.4
ACMEPACKET(snmp-community)#
Exiting and Saving
Elements
When you use the exit command and have not already saved your changes, the
ACLI produces the following message:
Save Changes y/n ? #
When this line appears, the ACLI is prompting you to save your configurations. This
prompt only appears if you have changed old information or entered new
information.
If you type anything other than a y in response to the Save Changes y/n ? # prompt,
the system will interpret that character as a
no response and will not save your work.
You must type a
y to save your work.