Installation guide

240 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS N-Z SIP-INTERFACE
ecf-address—Set the ECF address value that will be inserted into the P-Charging-
Function-Address header
secured-network—Enable or disable sending messages on unsecured transport
Default disabled
Values enabled | disabled
max-incoming-conns—Enter the maximum number of TCP/TLS connections for
this sip interface
Default 0
Values Min: 0 / Max: 40000; setting a value of 0 disables this parameter
per-scr-ip-max-incoming-conns—Enter the maximum number of TCP/TLS
connections per peer IP address
Default 0
Values Min: 0 / Max: 40000; setting a value of 0 disables this parameter.
inactive-conn-timeout—Enter the timeout, measured in seconds for idle TCP/TLS
connections
Default 0
Values Min: 0 / Max: 999999999; setting a value of 0 disables the timer.
implicit-service-route—Enable or disable the implicit service route behavior
Default disabled
Values • enabled
• disabled
• strict
rfc2833-payload—Enter the payload type used by the SIP interface in preferred
rfc2833-mode
Default 101
Values Min: 96 / Max: 127
rfc2833-mode—Choose whether the SIP interface will behave exactly the same
way as before and the 2833or UII negotiation will be transparent to the Net-Net
SBC, transparent, or whether the sip-interface prefers to use 2833 for DTMF
transfer and would signal that in its SDP, preferred. However the final decision
depends on the remote endpoint.
Default transparent
Values transparent | preferred | dual
trans-expire—Set the transaction expiration timer in seconds
Default 0
Values Min: 0 / Max: 999999999
invite-expire—Set the INVITE transaction expiration timer in seconds