Installation guide

252 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0

CONFIGURATION ELEMENTS N-Z SNMP-COMMUNITY

Path entries is a subelement of the sip-response-map element. The full path from the

topmost ACLI prompt is: configure terminal > session-router > sip-response-

map > entries.

Release First appearance: 1.1

RTC Status Supported

Notes This is a multiple instance configuration element.

snmp-community

The snmp-community element defines the NMSs from which the Net-Net SBC

will accept SNMP requests.

Syntax snmp-community <community-name | access-mode | ip-addresses |

select | no | show | done | exit>

Parameters community-name—Enter the name of the SNMP community to which a

particular NMS belongs. This required entry must follow the Name Format. The

community-name field values must be unique.

access-mode—Select the access level for each snmp-community element

Default READ-ONLY

Values • READ-ONLY—Allows GET requests

• READ-WRITE—Allows both GET and SET requests

ip-addresses—Enter the IP address(es) for SNMP communities for authentication

purposes. Entries must follow the IP Address Format.

Path snmp-community is an element under the system path. The full path from the

topmost ACLI prompt is: configure terminal > system > snmp-community.

Release First appearance: 1.0

RTC Status Unsupported

Notes This is a multiple instance configuration element.

static-flow

The static-flow element sets preconfigured flows that allow a specific class of traffic

to pass through the Net-Net SBC unrestricted.

Syntax static-flow <in-realm-id | description | in-source | in-

destination | out-realm-id | out-source | out-destination |

initial-guard-timer | subsq-guard-timer | average-rate-limit |

select | no | show | done | exit>

Parameters in-realm-id—Enter the ingress realm or interface source of packets to match for

static flow translation. This in-realm-id field value must correspond to a valid