Installation guide

254 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS N-Z STATIC-FLOW
protocol—Select the protocol for this static-flow. The protocol selected must match
the protocol in the IP header. The protocol remains the same for the inbound and
outbound sides of the packet flow.
Default UDP
Values • UDP—UDP used for this static-flow element
• TCP—TCP used for this static-flow element
• ICMP—ICMP used for this static-flow element
• ALL—Static-flow element can accept flows via any of the available
protocols.
alg-type—Select the type of NAT ALG to use
Default none
Values • none—No dynamic ALG functionality
• NAPT—Configure as NAPT ALG
• TFTP—Configure as TFTP ALG
average-rate-limit—Enter the maximum speed in bytes per second for this static
flow
Default 0
Values Min: 0 / Max: 125000000
start-port—Enter the internal starting ALG ephemeral port
Default 0
Values Min: 1025 / Max: 65535
end-port—Enter the internal ending ALG ephemeral port
Default 0
Values Min: 1025 / Max: 65535
flow-time-limit—Enter the time limit for a flow, measured in seconds
Values Min: 0 / Max: 999999999
initial-guard-timer—Enter the initial flow guard timer, measured in seconds
Values Min: 0 / Max: 999999999
subsq-guard-timer—Enter the subsequent flow guard timer, measured in seconds
Values Min: 0 / Max: 999999999
Path static-flow is an element under the media-manager path. The full path from the
topmost ACLI prompt is: configure terminal > media-manager > static-flow.
Release First appearance: 1.0 / Most recent update: 4.1
RTC Status Supported
Notes This is a multiple instance configuration element.