Installation guide

SYSTEM-ACCESS-LIST CONFIGURATION ELEMENTS N-Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 257
Values enabled | disabled
aor-count—Enter the number of registrations to do on behalf of this IP-PBX
Default 1
Values Min: 0 / Max: 999999999
auth-user—Enter the authentication user name you want to use for the surrogate
agent
max-register-attempt—Enter the number of times to attempt registration; a 0
value means registration attempts are unlimited
Default 3
Values Min: 0 / Max: 10
register-retry-time—Enter the amount of time in seconds to wait before
reattempting registration
Default 300
Values Min: 10 / Max: 3600
count-start—Enter the number of registrations to do on behalf of this IP-PBX
Default 1
Values Min: 0 / Max: 999999999
options—Enter non-standard options or features
Path surrogate-agent is an element under the session-router path. The full path from
the topmost ACLI prompt is: configure terminal > session-router > surrogate-
agent.
Release First appearance: 4.1; Last update: 5.1
system-access-list
The system-access-list configuration element allows you to configure system
access control of the management interface on your Net-Net SBC. Once configured,
any access from hosts that are not part of the system access IP address or subnet are
denied. When this element is not configured, any host can access management
ports.
Syntax system-access-list <source-address | netmask | description |
select | no | show | done | exit>
source-address—Enter the network source address
netmask—Enter the source subnet mask
description—Provide a brief description of this system-access-list configuration.
Path system-access-list is an element of the system path. The full path from the
topmost ACLI prompt is: configure terminal > system> system-access-list.