Installation guide

258 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS N-Z SYSTEM-CONFIG
Release First appearance: 5.0
RTC Status Supported
system-config
The system-config element establishes general system information and settings.
Syntax system-config <hostname | description | location | mib-system-
contact | mib-system-name | mib-system-location | snmp-enabled |
enable-snmp-auth-traps | enable-snmp-syslog-notify | enable-snmp-
monitor-traps | enable-env-monitor-traps | snmp-syslog-his-
table-length | snmp-syslog-level | syslog-servers | system-log-
level | process-log-level | process-log-ip-address | process-log-
port | collect | default-gateway | restart | call-trace |
internal-trace | log-filter | remote-control | alarm-threshold |
exceptions | telnet-timeout | console-timeout | link-redundancy-
state | cli-audit-trail | source-routing | cli-more | terminal-
height | debug-timeout | trap-event-lifetime | options | select |
no | show | done | exit>
Parameters hostname—Enter the main hostname that identifies the Net-Net SBC. Entries
must follow either the Hostname (or FQDN) Format or the IP Address Format.
description—Describe the Net-Net SBC. Entries must follow the Text Format.
location—Enter the physical location of the Net-Net SBC used for informational
purposes. Entries must follow the Text Format.
mib-system-contact—Enter the contact information for this Net-Net SBC for
SNMP purposes. This field value is the value reported for MIB-II when an SNMP
GET is issued by the NMS. Entries must follow the Text Format.
mib-system-name—Enter the identification of the Net-Net SBC for SNMP
purposes. This value has no relation to the system-config > hostname field. By
convention, this is the node’s FQDN. If this field remains empty, the Net-Net SBC
name that appears in SNMP communications will be the target name configured in
the boot parameters and nothing else.
mib-system-location—Enter the physical location of the Net-Net SBC for SNMP
purposes. This parameter has no direct relation to the location field identified
above. Entries must follow the Text Format.
snmp-enabled—Enable or disable SNMP is enabled. If SNMP is enabled, then the
system will initiate the SNMP agent. If SNMP is disabled, then the SNMP agent
will not be initiated, and the trap-receiver and snmp-community elements will not
be functional.
Default enabled
Values enabled | disabled
enable-snmp-auth-traps—Enable or disable the SNMP authentication traps