Installation guide

264 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
CONFIGURATION ELEMENTS N-Z SYSTEM-CONFIG>COLLECT>PUSH-RECEIVER
Default disabled
Values enabled | disabled
Notes This parameter is not RTC supported.
red-collect-state—Enable or disable HA support for the collection function
Default disabled
Values enabled | disabled
red-max-trans—Enter the maximum number of redundancy sync transactions to
keep on active
Default 1000
Values Min: 0 / Max: 999999999
red-sync-start-time—Enter the time to start redundancy sync timeout, in
milliseconds.
Default 5000
Values Min: 0 / Max: 999999999
red-sync-comp-time—Enter the time to complete a redundancy sync, in
milliseconds.
Default 1000
Values Min: 0 / Max: 999999999
push-receiver—Access the push-receiver subelement
group-settings—Access the group-settings subelement
push-success-trap-state—Enable this parameter if you want the Net-Net SBC to
send a trap confirming successful data pushes to HDR servers
Default disabled
Values enabled | disabled
Path collect is a subelement of the system-config element. The full path from the
topmost ACLI prompt is: configure terminal > system > system-config > collect.
Release First appearance: 5.0
RTC Status Supported
system-config>collect>push-receiver
The push-receiver configuration subelement allows you to configure the Net-Net
SBC to push collected data to a specified node.
Syntax push-receiver <address | user-name | password | data-store |
protocol | select | no | show | done | exit>
Parameters address—Enter the hostname or IP address to which the Net-Net SBC pushes
collected data
user-name—Enter the login user name for the specified server used when pushing
collected data