Installation guide

PASSWORD-SECURE-MODE ACLI COMMANDS N - Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 61
• local-port—Layer 4 port number on which the Net-Net SBC
receives and from which it sends. This is an optional parameter;
if no port is specified or if it is set to 0, then all ports will be
traced.
• remote-port—Layer 4 port to which the Net-Net SBC sends and
from which it receives. This is an optional parameter; if no port
is specified or if it is set to 0, then all ports are traced.
<stop> Manually stop packet tracing on the Net-Net SBC. With this
command you can either stop an individual packet trace or all packet traces that the
Net-Net SBC is currently conducting.
• network-interface—The name of the network interface on the
Net-Net SBC from which you want to stop packet tracing. This
value can be entered either as a name alone or as a name and
subport identifier value (name:subportid).
• ip-address—IP address of the endpoint to and from from which
you want the Net-Net SBC to stop mirroring calls.
• local-port—Layer 4 port number on which to stop from
receiving and sending. This is an optional parameter; if no port
is specified or if it is set to 0, then all port tracing will be stopped.
• remote-port—Layer 4 port number on which to stop the Net-
Net SBC from receiving and sending. This is an optional
parameter; if no port is specified or if it is set to 0, then all port
tracing will be stopped.
Mode Superuser
Release First appearance: 5.0
Example ACMEPACKET# packet-trace start public:0 111.0.12.5
password-secure-mode
The password-secure-mode command allows you to enable and view the status of
the password secure mode functionality on the Net-Net SBC.
Syntax password-secure-mode <enable> <status>
Arguments <enable> Enable the password secure mode on the Net-Net SBC
<status> Display the current status of the password secure mode
functionality on the Net-Net SBC.
Mode Superuser
Release First appearance: 5.0
Example ACMEPACKET# password-secure-mode enable