Installation guide

68 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
ACLI COMMANDS N - Z SET-FRONT-INTERFACE
Example ACMEPACKET# secret login
set-front-interface
The set-front-interface command quickly sets the parameters of the front media
interfaces. This command is used to configure front interfaces on a one time basis.
Use the phy-interface configuration element to permanently configure a physical
interface.
set-front-interface admin-state
Syntax set-front-interface <slot> <port> <admin state>
Arguments <slot> Select the media interface slot
Values • 0—Left slot
• 1—Right slot
<port> Select the media interface port
Values • 0—Leftmost port
• 1—Second from left port
• 2—Third from left port (not applicable for GigE cards)
• 3—Rightmost port (not applicable for GigE cards)
<admin state> Select the interface admin state
Values • enabled—Enable the administrative state
• disabled—Disable the administrative state
Notes This command sets administrative mode for the front interfaces. Values configured
via the set-front-interface admin-state command take effect at runtime, and are
not persistent after a reboot.
For information about the admin-state field, refer to its description in the phy-
interface section of this document.
Example ACMEPACKET# set-front-interface admin-state 0 3 enabled
set-front-interface auto-negotiation
Syntax set-front-interface auto-negotiation <slot> <port> <state>
Arguments <slot> Select the media interface slot
Values • 0—Left slot