Installation guide

SET-FRONT-INTERFACE ACLI COMMANDS N - Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 69
• 1—Right slot
<port> Select the media interface port
Values • 0—Leftmost port
• 1—Second from left port
• 2—Third from left port (not applicable for GigE cards)
• 3—Rightmost port (not applicable for GigE cards)
<state> Select the interface admin state
Values • enabled—Enable auto-negotiation
• disabled—Disable auto-negotiation
Notes This command sets the auto-negotiation protocol for the front interfaces. Values
configured via the auto-negotiation command take effect at runtime.
Example ACMEPACKET# set-front-interface auto-negotiation 1 2 disabled
set-front-interface duplex-mode
Syntax set-front-interface duplex-mode <slot> <port> <duplex mode>
Arguments <slot> Select the media interface slot
Values • 0—Left slot
• 1—Right slot
<port> Select the media interface port
Values • 0—Leftmost port
• 1—Second from left port
• 2—Third from left port (not applicable for GigE cards)
• 3—Rightmost port (not applicable for GigE cards)
<duplex mode> Select the interface duplex mode
Values • full—Enable full-duplex mode on the selected FastE
interface
• half—Enable half-duplex mode on the selected FastE
interface
Notes This command sets full-duplex or half-duplex mode for the Net-Net SBC’s front
interfaces (10/100 physical interface cards only). Values configured via the duplex-
mode command take effect at runtime and are persistent across reboot.
Example ACMEPACKET# set-front-interface 0 0 full