Installation guide

80 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
ACLI COMMANDS N - Z SHOW
Executing the show h323 command without any arguments will return the same
output as using the status argument.
Example ACMEPACKET# show h323d status
show health
Syntax show health
In HA architectures, the show health command displays the following information:
• Health score
• Current Net-Net SBC HA state as active, standby, or out of service
• If media flow information is synchronized for all supported protocols: SIP,
H.323, and MGCP (true/false). If media flow information is not available,
Media
Synchronized disabled will be displayed in the show health output.
• If SIP signaling information is synchronized (true/false). If SIP signaling is not
available,
SIP Synchronized disabled will be displayed in the show health
output.
• If MGCP signaling information is synchronized (true/false). If MGCP signaling
is not available,
MGCP Synchronized disabled will be displayed in the show
health output.
• If configuration information is synchronized (true/false). If configuration
checkpointing is not available,
Config Synchronized disabled will be
displayed in the show health output.
• IP address of the current HA Net-Net SBC’s active peer (no peer is denoted with
an IP address of 0.0.0.0)
• Last message received from the HA Net-Net SBC peer
• A switchover log containing the last 20 switchover events
Example ACMEPACKET# show health
show hosts
Syntax show hosts
The show hosts command shows a list of remote hostnames, their IPv4 addresses,
and aliases.
Examples ACMEPACKET# show hosts
show interfaces
Syntax show interfaces [brief]