Installation guide

SHOW ACLI COMMANDS N - Z
Version S-C6.1.0 Oracle Communications Session Border Controller ACLI Reference Guide 81
The show interfaces command shows all information concerning the Net-Net
SBC’s rear interfaces:
• Flags (such as loopback, broadcast, promiscuous, ARP, running, and debug)
• Type
• Internet address
• VLAN ID (if applicable)
• Broadcast address (if applicable)
• Netmask
• Subnet mask (if applicable)
• Gateway (if applicable)
• Ethernet (MAC) address (if applicable)
• Route metric
• Maximum transfer unit size
• Number of octets sent and received on this interface (if applicable)
• Number of packets sent and received on this interface
• Number of non-unicast packets sent and received on this interface (if
applicable)
• Number of unicast packets sent and received on this interface (if applicable)
• Number of multicast packets sent and received on this interface (if applicable)
• Number of input discards (if applicable)
• Number of input unknown protocols (if applicable)
• Number of input and output errors
• Number of collisions
• Number of drops
This command also displays information for loopback interfaces.
Arguments <brief> Allows you to view key running statistics about the interfaces
within a single screen. This is an optional argument.
Example ACMEPACKET# show interfaces
show ip
Syntax show ip <ip-stats>
Displays IP statistics for your Net-Net SBC.
Arguments <ip-stats> The following is a list of valid ip-stats:
Values • statistics—Display detailed IP statistics
• connections—Display all TCP and UDP connections