Installation guide

94 Oracle Communications Session Border Controller ACLI Reference Guide Version S-C6.1.0
ACLI COMMANDS N - Z SHOW
show nsep-stats
Syntax show nsep-stats [all | rvalue]
The show nsep-stats command displays information about inbound sessions and r-
values.
Arguments <all> Display information about inbound sessions and r-values for
the Net-Net SBC’s NSEP support feature. This is an optional
argument.
<rvalue> View statistics for a specific r-value. An r-value is a namespace
and priority combination entered in the following format:
namespace.priority. The display also shows the specified r-
value for which it is displaying data. This is an optional
argument.
Mode User, Superuser
Release First appearance: 5.1
show ntp
Syntax show ntp <arguments>
The show ntp command displays information about NTP servers configured for use
with the system
Arguments <arguments> The following is a list of valid arguments:
Values • servers—Display information about the quality of the time
being used in terms of offset and delay measurement;
maximum error bounds are also displayed
• status—Display information about configuration status,
NTP daemon synchronization, NTP synchronizations in
process, if NTP is down
Mode User, Superuser
Release First appearance: 5.1
Example ACMEPACKET# show ntp servers
show packet-trace
Syntax show packet-trace
The show packet-trace command allows you to check whether the Net-Net SBC’s
tracing status is currently enabled or disabled.