User manual

33
Make sure that there is sufficient air circulation and a dry and clean area while charging.
!!!Pay attention on the warning- and security notices!!!
Connect the power cable to the charger and then to your power outlet (100-240V).
Once the charger is ready for use, a red/green blinking will appear.
Connect the LiPo- batteries balancer cable (white plug) with the chargers front port.
Please note that it can only be plugged in one direction! The cable with the T-plug (black/red) are not required
for charging.
Charging starts automatically.
The three LEDs on the charger will light up in red.
Depending the batteries capacity, charging takes up to 1 till 1.5 hours. Each cell (3pcs) are being charged one
another.
As soon as one cell is fully charged, the matching LED switches to green, this may happen in various orders.
The battery is fully charged and ready for use as soon as all LEDs turn green. After you have carefully
disconnected the battery from the charger, the LEDs turn to standby mode again (Green/red flash).
NOTE:
If you disconnect the battery before charging is complete, the charger automatically switches to standby mode.
If the battery charger detects an overload or short circuit, charging stops automatically.
Battery maintenance
Please note the following steps to ensure a long battery life:
- Never store the model with connected battery and disconnect the battery after every use
- Before you store the battery for a longer time, make sure that it is charged (minimum 50%)
- Disconnect the battery from the model
- Always store at regular room temperature
- Constantly charge the battery every 3 months if you are not using it
Disregarding these steps may lead into total damage of the LiPo- battery due to the batteries physically
conditions.
Batteryvoltages
Battery charged 100%: Every cell has approx. 4.2V, total voltage 12.6V
Battery charged 90%: Every cell has approx. 4.0V, total voltage 12.0V
Battery charged 75%: Every cell has approx. 3.9V, total voltage 11.7V
Battery charged 50%: Every cell has approx. 3.7V, total voltage 11.1V
Battery charged 20%: Every cell has approx. 3.6V, total voltage 10.8V
Never connect two batteries at once!