Manual

2-3.3 Jumper Settings
1. Clear CMONS Jumper (CLRCMOS1) [refer to P.13, No. 16]
It allows you to clear the data in CMOS. To clear and reset the system parameters to default
setup, please turn off the computer and unplug the power cord from the power supply. After
waiting for 15 seconds, use a jumper cap to short pin 2 and pin 3 on CLRCMOS1 for 5 seconds.
However, please do not clear the CMOS right after you update the BIOS. If you need to clear the
CMOS when you just finish updating the BIOS, you must boot up the system first, and then shut it
down before you do the clear-CMOS action. Please be noted that the password, date, time, user
default profile and MAC address will be cleared only if the CMOS battery is removed.
2. Digital I/O Header PWR Setting (3-pin JGPIO_PWR1) [refer to P.13, No.14]
3. PWR-On Mode Setting (3-pin PWR_JP1) [refer to P.13, No.17]
4. Panel VDD PWR Setting (3-pin PNL_PWR1) [refer to P.13, No.26]
5. Panel BackLight PWR Setting (3-pin BKT_PWR1) [refer to P.13, No. 27]