Instruction Manual
Jumper Setting
The VGA port is used for connecting a VGA monitor. Connect the monitors 15-pin D-shel
port. After you plug the monitors cable connector into the VGA port, gently tighten the ca
connector in place.
BIOS Setting
Configure VGA in the Chipset menu (North Bridge Configuration submenu) of the BIOS.
information.
Wake-ON-PS/2 Keyboard/Mouse
The Wake-On-PS/2 Keyboard/Mouse function allows you to use the PS/2 keyboard or PS/2 mouse to power-on the
system. To use this function:
Jumper Setting
JP2 must be set to 2-3 On: +5V_standby. Refer to PS/2 Power Select in this chapter for more information.
BIOS Setting
Configure the PS/2 keyboard/mouse wake up function in the Advanced menu (ACPI Power Management
Configuratio submenu) of the BIOS. Refer to chapter 3 for more information.
Important:
The +5V_standby power source of your power supply must support д720mA.
COM (Serial) Ports
COM 3 to COM 6 are fixed at RS232. The pin function of COM 1 and COM 2 ports will vary according to JP4/JP5s
setting. Refer to COM1/COM2 RS232/RS422/RS485 Select in this chapter for more information. The serial ports are
asynchronous communication ports with 16C550A-compatible UARTs that can be used with modems, serial printers,
remote display terminals, and other serial devices.
BIOS Setting
Configure the serial ports in the advanced menu (Super IO Configuratio submenu) of the BIOS. Refer to chapter 3
for more information.
VGA Port
l cable connector to the VGA
ble screws to hold the
Refer to chapter 3 for more
Driver Installation
Install the graphics driver. Refer to chapter 4 for more information.