ACOEM Advanced acoustic detector : User's Manual : Page 21

On the same System page, on the bottom part (use the scrolling bar on the right), you have the

Time settings section. This part is to setup the NTP server used by the pod.

By default the pod NTP server field is blank, in this case the NTP server used is a public internet

NTP server.

You can edit the NTP server field to use a local NTP server or an internet one. To apply the

new setting, press the Apply button and reboot the pod.

Figure 10: System web page to setup the NTP server

Remark:

1. The NTP protocol is the only way to set the time on the pod

2. Have the exact time is a mandatory to use the ONVIF protocol (connection with the

camera) and have a correct history of the event

3. The time used on the pod is always UTC

4. You need to refresh the System page to update the time of the pod

5. On the Status Web page you can check if the pod is synchronized with the NTP server.

The time synchronization can take several minutes after a reboot

ACOEM | ATD-300/ATD-301 | User Manual FW 1.0.0.4 21