User's Manual
To setup the communication with the ATD server please complete the following field:
● Server address ⇒ IP address of the ATD server
● Server port ⇒ Port of the ATD server
● Frame record Server address ⇒ IP address of the ATD server, usually identical than
the Server address
● Frame record Server port ⇒ Port of the ATD server, usually identical than the Server
port
To apply the new setting, press the Save button and reboot the pod.
Remark:
● The Device identifier is the pod Serial Number and can not be modified by user
● The Alarm URL is a http command user defined, send in case of threat to an external
device (the same command will be send for each type of threat)
● If the Frame record Server is blank then no Frame will be sent to the server. In this
case no raw data are stored
ACOEM | ATD-300/ATD-301 | User Manual FW 1.0.0.4 35