User's Manual

4.9.2. Demo mode
When the demo mode is enabled, the AI of the pod is not used. All the process to detect and
classify the noise is replaced by a simple threshold detector. Therefore it is possible to simulate
a fake Gunshot and validate all the settings for the camera and pod angle with impulsive noise.
To simulate a gunshot, use some wood plate or metallic tools to have impulse noise. To have a
good localization process it is mandatory to have impulsive noise.
To enter on the Demo mode first set a Duration (min) in minutes and press the Apply button.
After this time, the pod will reboot to come back to ATD mode.
You can check that you are on the Demo mode on the Status page.
On the Status page, the pod mode changes to Demo. You also have the Threshold (dB) of the
demo mode, this value define in dB the sensitivity of the system during the demo. You can
change it on the Modes web page
The End of the Demo Mode (UTC) inform about the UTC time when the pod will reboot and
restart on the ATD mode.
Figure 24: Status web page for the ATD-300/ATD-301 demo mode
ACOEM | ATD-300/ATD-301 | User Manual FW 1.0.0.4 38