ACOEM Advanced acoustic detector : User's Manual : Page 41

4.11. Factory menus

On the ATD-300/ATD-301 web page, there are two last pages for troubleshooting and

maintenance.

Figure 29: Factory menus

On Debug page it will be possible to push specific frames on the ATD server during a specific

period. To be able to use this mode, the pod as to be connected to the ATD server and the

Frame record server address setup on the Settings page. When the ATD-300/ATD-301 pod

is on debug mode, you will find Enable for Debug recording status on the Status page.

The Calibration page is only for maintenance to calibrate the microphone after repair. The

ATD-300/ATD-301 no need calibration during its lifetime.

ACOEM | ATD-300/ATD-301 | User Manual FW 1.0.0.4 41