User's Manual

5.2. Installation with bracket
For long terme installation or for a wall installation a bracket has to be used to fix the pod. The
bracket is an option and is not delivered in standard. Please contact the ACOEM sale service if
you need a bracket.
5.2.1. Installation on a mast
The bracket has 4 openings of 20mm high to fix the bracket and the pod to a mast with 2
metallic strips.
Figure 31: Installation of the ATD-300/ATD-301 braket on a mast
For a safe installation the requirements below must be followed:
● The mast has to be designed to support the weight of the pod/bracket and all the
additional load entailed by the pod installation and external factor (wind, snow….)
● The metallic strip has to be selected to support the pod/bracket weight
● The metallic strip must be chosen to resist to climatic and environmental constraints
● The metal strip must be tight enough to prevent any movement
● Connect the Ethernet cable on the pod and fix the Ethernet cable on the mast to avoid
any mouvement
ACOEM | ATD-300/ATD-301 | User Manual FW 1.0.0.4 44