User's Manual

6. ATD SERVER SOFTWARE INSTALLATION
6.1. Introduction
This procedure explains how to install the ATD server on an Ubuntu Linux server. To simplify
the IT architecture, the ATD server software runs on the Docker solution.
The ATD server is not mandatory to have a functional system, if you don’t need it you can skip
this section. The main function of the ATD server are:
● Log the threat
● Log and check the state of life of each pod
● Have a map with the noise level measured by each pod in real time
● Have a map with the threat detected by each pod in real time
● Store the frame of each event for AI training
The prerequisites to run the ATD server are:
● OS:
○ Ubuntu Focal 20.04 (LTS) – 64-bit version
○ Ubuntu Bionic 18.04 (LTS) – 64-bit version
● Docker Engine with compose installed
● HDD: At least 100Go available to save the frame
● RAM: At least 4Go
● Processor: Minimum 2GHz dual core processor x86/amd64 architecture
Remark:
● This installation has to be done by qualified IT technician with Linux skill
ACOEM | ATD-300/ATD-301 | User Manual FW 1.0.0.4 49